National Instruments FP-1600, network module quick start Lock rail clip

Page 2

DIN Rail Mount

NOTE: Do not use spliced DIN rails. Use only a single DIN rail.

B. Hook lip on back of module onto top of DIN rail, press down, and snap into place.

C. Slide module into position and lock rail clip.

Panel Mount

B. Snap panel mount accessory (which you can order separately) onto module.

C. Lock rail clip.

D. Use template that came with your accessory to drill pilot holes and mount module onto

panel using accessory.

2

Image 2

Contents What You Need to Get Set Up Install the Network ModuleLock rail clip Install the Terminal Bases Place protective cover on last base Install the I/O Modules Connect the Network CablesWire Power to Your FieldPoint System FP-1600 FP-AI-100 FP-AO-200 Connect to Field Devices FP-AI-110Power Up Your FieldPoint System Install the FieldPoint Software Verify the InstallationEthernet as the Type IP address is the address of the FP-1600 on the network Click on Find DevicesSelect File»Save Configure I/O Modules Select File»Save when you are done Where to Go from Here FP-1600 Specifications 11 to 30 VDCMechanical Dimensions Copyright 1999, 2000 National Instruments Corporation