Cisco Systems UCSEZINFRACHSS manual Repacking the Chassis, SFP+ Transceivers, Model Description

Installation

Repacking the Chassis

Step 2 Disconnect the power cords and networking cables from the chassis.

Step 3 Remove all modules and blades from the chassis to lighten its weight.

Step 4 Remove the screws holding the front rack-mount flange to the rack.

Step 5 With two people holding the chassis, make sure that its weight is fully supported.

Step 6 Gently slide the chassis off the rails, and out of the rack.

Step 7 Replace the modules and blades in the server chassis.

Repacking the Chassis

If you need to repack the chassis, remove it from the rack by reversing the steps in the Removing the Chassis from a Rack, on page 50 section, and then pack it for shipment. If possible, use the original packing materials and container to pack the chassis. If you are returning the chassis to Cisco, contact your Cisco customer service representative to arrange for return shipment to Cisco.

SFP+ Transceivers

Each FEX within the chassis supports Small Form-Factor Pluggable (SFP+) copper or optical transceivers. Each transceiver runs at 10 Gb.

SFP+ Twinax Copper Transceivers

The FEX also supports Twinax copper transceivers. The enhanced SFP+ 10-Gb Ethernet transceiver is a bidirectional device with a transmitter and receiver in the same physical package. It has a 20-pin connector on the electrical interface.

Table 7: SFP+ 10 Gb Ethernet Transceiver
Model	Description
SFP-H10GB-CU1M	10-Gb Ethernet—copper SFP+ (1 m, 3.28 ft.)
SFP-H10GB-CU3M	10-Gb Ethernet—copper SFP+ (3 m, 9.84 ft.)
SFP-H10GB-CU5M	10-Gb Ethernet—copper SFP+ (5 m, 16.4 ft.)
SFP-H10GB-ACU7M	10-Gb Ethernet—copper SFP+ (7 m, 22.9 ft.)
SFP-H10GB-ACU10M	10-Gb Ethernet—copper SFP+ (10 m, 32.8 ft.)

Cisco UCS 5108 Server Chassis Installation Guide

OL-20035-05 51