Cisco Systems UCSEZINFRACHSS manual Installing and Removing Power Supplies

Installing and Removing Components

Installing and Removing Power Supplies

Removing a Blade Server Hard Drive

Procedure

Step 1 Push the button to release the ejector, and then pull the hard drive from its slot.

Figure 35: Pressing the Button on the Front of the Hard Drive to Deploy the Lever (Cisco UCS B200 M1 shown)

1 Release button 2 Hard drive lever

Step 2 Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another blade server.

Step 3 Install a blank faceplate (N20-BBLKD) to keep dust out of the blade server if the slot will remain empty.

Installing and Removing Power Supplies

Note The AC and DC power supplies are keyed to work only with the power distribution system in their respective chassis version. Mixing AC and DC in a given chassis is not supported.

Cisco UCS 5108 Server Chassis Installation Guide

OL-20035-05 59