Installation
Connecting a DC Power Supply
Note Both grids in a power redundant system should have the same number of power supplies. If your system is configured for grid redundancy, slots 1 and 2 are assigned to grid 1 and slots 3 and 4 are assigned to grid 2. If only two power supplies (PS) are in a redundant- mode chassis, they should be in slots 1 and 3. Slot and cord connection numbering is shown below.
Figure 25: Power Supply Bay and Connector Numbering
Front
Server Slot 1
Server Slot 3
Server Slot 5
Server Slot 7
PS 1 |
| PS 2 |
|
|
|
Server Slot 2
Server Slot 4
Server Slot 6
Server Slot 8
PS 3 |
| PS 4 |
|
|
|
|
| Fan 1 | Fan 2 |
|
|
| Fan 3 | Fan 4 |
| Module Slot 1 |
|
| Module Slot 2 |
|
|
|
|
|
|
|
|
|
|
| ||
| Fan 5 | Fan 6 |
|
| Fan 7 | Fan 8 | ||
| I/O | I/O |
|
| ||||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| Connector | Connector |
| Connector | Connector | ||
Rear |
| PS 4 | PS 3 |
| PS 2 | PS 1 | ||
|
|
|
|
|
|
|
| |
279770
Step 6 Connect the server chassis to the fabric interconnect as described in Proper FEX and Fabric Interconnect Port Connectivity, on page 48.
Connecting a DC Power Supply
This section describes how to connect power to the rear PDU terminals on the DC version chassis
Required Tools
You must have the following tools to perform this procedure:
•A Phillips screwdriver
•A
•Connectors and wire for the DC circuit or circuits
DC Power Installation Procedure
Warning When stranded wiring is required, use approved wiring terminations, such as
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement 1003
Cisco UCS 5108 Server Chassis Installation Guide
44 |
|