Dell R210 II owner manual System Messages, Message Causes Corrective Actions

System Messages

System messages appear on the screen to notify you of a possible problem with the system.

NOTE: If you receive a system message not listed in the table, check the documentation for the application that is running when the message appears or the operating system's documentation for an explanation of the message and recommended action.

Message	Causes	Corrective Actions
BIOS	System is in manufacturing	Reboot to take the system
MANUFACTURING	mode.	out of manufacturing mode.
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.

Caution!	NVRAM_CLR jumper is
NVRAM_CLR jumper	installed in the clear setting.
is installed on	CMOS has been cleared.
system board.
Please run
SETUP.

Move the NVRAM_CLR jumper to the default position (pins 3 and 5). See Figure 6-1 for jumper location. Restart the system and re-enter the BIOS settings. See "Using the System Setup Program and Boot Manager" on page 25.

Invalid	An invalid system	Run the System Setup
configuration	configuration caused a	program and review the
information -	system halt.	current settings. See "Using
please run SETUP		the System Setup Program
program.		and Boot Manager" on
		page 25.
Keyboard	Faulty keyboard controller;	See "Getting Help" on
controller	faulty system board.	page 119.
failure.

About Your System

19