iDRAC6 Enterprise Card (Optional)
Installing an iDRAC6 Enterprise Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening the System" on page 50.
3If installed, remove the expansion card from the expansion slot. See "Removing an Expansion Card" on page 61.
4Remove the plastic filler plug for the iDRAC6 Enterprise port from the system back panel.
5Angle the card so that the
6Align the front edge of the card with the two front plastic retention standoffs next to the iDRAC6 connector on the system board, and lower the card into place. See Figure
When the front of the card is fully seated, the plastic standoffs snap over the edge of the card.
Installing System Components
79