Packard Bell A7 manual Removing the LCD Module, Disconnecting the keyboard flat cable

Page 15

5. Lift up the keyboard and disconnect it from the system as shown in Fig. 17

Fig. 17 Disconnecting the keyboard flat cable

Removing the LCD Module

To remove the LCD Module first remove the battery (see Removing the Battery), remove WLAN Card Module (see Removing WLAN Card Module)and remove the Keyboard (see Removing the Keyboard) then perform the following steps:

1. Release LCD cable from base unit.

Fig. 18 Releasing LCD cable

NEC Versa S940/PB EasyNote A7 Disassembly Manual

Page 15

Image 15

Contents Versa S940 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewPower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge Removing the battery Removing the BatteryRemoving the screws retaining the memory module slot cover Removing the Memory ModuleWlan Card Module Removing the Wlan Card ModuleRemoving the Hard disk drive cover Removing the Hard Disk DriveRemove four screws that around HDD module Eject the optical drive Removing the Optical Disk DriveRemoving the screws retaining CPU cover Removing the CPUUnlocking the CPU Releasing the keyboard cover Removing the KeyboardUnscrew two screws at the bottom as shown in Fig Removing the LCD Module Disconnecting the keyboard flat cableCarefully lift up the LCD Module Removing the rubber covers & screws on the LCD Module Removing the LCD PanelDisconnect all connectors on inverter board as shown in Fig Bottom Cover Removing the Top CoverCarefully lift up the Top Cover Main board Removing the Main BoardDisconnect Audio board from main board as shown in Fig Removing the Touch Pad Removing the Speaker AssemblyScrews DIP Switch SettingsVersa S940/EasyNote A7 Disassembly Manual