Packard Bell A7 manual Removing the Battery, Removing the battery

Page 5

Removing the Battery

Perform the following steps to remove the battery:

1.Make sure to power off the Versa S940/EasyNote A7.

2.Turn the unit upside down.

3.Unlock the battery and slide it out of its place as the arrow shows in Fig. 1

Fig. 1 Removing the battery

NEC Versa S940/PB EasyNote A7 Disassembly Manual

Page 5

Image 5

Contents Versa S940 Disassembly Manual Table of contents Reassembly Instructions Disassembly InstructionsOverview Technician NotesAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage Removing the battery Removing the BatteryRemoving the screws retaining the memory module slot cover Removing the Memory ModuleWlan Card Module Removing the Wlan Card ModuleRemoving the Hard disk drive cover Removing the Hard Disk DriveRemove four screws that around HDD module Eject the optical drive Removing the Optical Disk DriveRemoving the screws retaining CPU cover Removing the CPUUnlocking the CPU Releasing the keyboard cover Removing the KeyboardUnscrew two screws at the bottom as shown in Fig Removing the LCD Module Disconnecting the keyboard flat cableCarefully lift up the LCD Module Removing the rubber covers & screws on the LCD Module Removing the LCD PanelDisconnect all connectors on inverter board as shown in Fig Bottom Cover Removing the Top CoverCarefully lift up the Top Cover Main board Removing the Main BoardDisconnect Audio board from main board as shown in Fig Removing the Touch Pad Removing the Speaker AssemblyScrews DIP Switch SettingsVersa S940/EasyNote A7 Disassembly Manual