Packard Bell A7 manual Removing the Hard Disk Drive, Removing the Hard disk drive cover

Page 8

Removing the Hard Disk Drive

To remove the hard disk drive, first remove the battery (see Removing the Battery), then perform the following steps:

1. Remove the screws as shown in Fig. 5

Fig. 5 Removing the Hard disk drive cover

2. Carefully pull the HDD module out from the base unit.

M2.5x8 Copper

Fig. 6 Pulling HDD module

NEC Versa S940/PB EasyNote A7 Disassembly Manual

Page 8

Image 8

Contents Versa S940 Disassembly Manual Table of contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage Removing the Battery Removing the batteryRemoving the Memory Module Removing the screws retaining the memory module slot coverRemoving the Wlan Card Module Wlan Card ModuleRemoving the Hard Disk Drive Removing the Hard disk drive coverRemove four screws that around HDD module Removing the Optical Disk Drive Eject the optical driveRemoving the CPU Removing the screws retaining CPU coverUnlocking the CPU Removing the Keyboard Releasing the keyboard coverUnscrew two screws at the bottom as shown in Fig Disconnecting the keyboard flat cable Removing the LCD ModuleCarefully lift up the LCD Module Removing the LCD Panel Removing the rubber covers & screws on the LCD ModuleDisconnect all connectors on inverter board as shown in Fig Removing the Top Cover Bottom CoverCarefully lift up the Top Cover Removing the Main Board Main boardDisconnect Audio board from main board as shown in Fig Removing the Speaker Assembly Removing the Touch PadDIP Switch Settings ScrewsVersa S940/EasyNote A7 Disassembly Manual