Packard Bell A7 manual Removing the Optical Disk Drive, Eject the optical drive

Page 10

Removing the Optical Disk Drive

To remove the ODD, first remove the battery (see Removing the Battery) and Memory Module Cover (see Removing Memory Module) then perform the following steps:

1. Use pin to eject the optical drive via emergency eject hole as shown in Fig. 8

Fig. 8 Eject the optical drive

1. Pull the ODD module out from the base unit as shown in Fig. 9

Fig. 9 Pulling the optical drive out from the base unit

NEC Versa S940/PB EasyNote A7 Disassembly Manual

Page 10

Image 10

Contents Versa S940 Disassembly Manual Table of contents Overview Disassembly InstructionsReassembly Instructions Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Battery Removing the batteryRemoving the Memory Module Removing the screws retaining the memory module slot coverRemoving the Wlan Card Module Wlan Card ModuleRemoving the Hard Disk Drive Removing the Hard disk drive coverRemove four screws that around HDD module Removing the Optical Disk Drive Eject the optical driveRemoving the CPU Removing the screws retaining CPU coverUnlocking the CPU Removing the Keyboard Releasing the keyboard coverUnscrew two screws at the bottom as shown in Fig Disconnecting the keyboard flat cable Removing the LCD ModuleCarefully lift up the LCD Module Removing the LCD Panel Removing the rubber covers & screws on the LCD ModuleDisconnect all connectors on inverter board as shown in Fig Removing the Top Cover Bottom CoverCarefully lift up the Top Cover Removing the Main Board Main boardDisconnect Audio board from main board as shown in Fig Removing the Speaker Assembly Removing the Touch PadDIP Switch Settings ScrewsVersa S940/EasyNote A7 Disassembly Manual