Packard Bell A7 manual Removing the Wlan Card Module

Page 7

Removing the WLAN Card Module

To remove the WLAN Card Module, first remove the Memory Module Cover (see Removing Memory Module) then perform the following steps:

1.Disconnect the wireless antenna connector and release the WLAN Card Module as shown in Error! Reference source not found.

Fig. 4 WLAN Card Module

2. Lift up the WLAN Card Module and put it aside.

NEC Versa S940/PB EasyNote A7 Disassembly Manual

Page 7

Image 7

Contents Versa S940 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the battery Removing the BatteryRemoving the screws retaining the memory module slot cover Removing the Memory ModuleWlan Card Module Removing the Wlan Card ModuleRemoving the Hard disk drive cover Removing the Hard Disk DriveRemove four screws that around HDD module Eject the optical drive Removing the Optical Disk DriveRemoving the screws retaining CPU cover Removing the CPUUnlocking the CPU Releasing the keyboard cover Removing the KeyboardUnscrew two screws at the bottom as shown in Fig Removing the LCD Module Disconnecting the keyboard flat cableCarefully lift up the LCD Module Removing the rubber covers & screws on the LCD Module Removing the LCD PanelDisconnect all connectors on inverter board as shown in Fig Bottom Cover Removing the Top CoverCarefully lift up the Top Cover Main board Removing the Main BoardDisconnect Audio board from main board as shown in Fig Removing the Touch Pad Removing the Speaker AssemblyScrews DIP Switch SettingsVersa S940/EasyNote A7 Disassembly Manual