Eicon Networks Diva 2430 manual Power light is blinking red

Page 32

Setup: Troubleshooting

Page 32

•If your Diva 2430 is connected to a LAN, make sure it is the only device with the IP address 192.168.1.1. To verify, ping the address 192.168.1.1. If you get a reply, disconnect the Diva 2430 from your LAN and ping 192.168.1.1 again. If you still get a reply, you have two devices on the same LAN with the same IP address. In this case you will have to change the IP address of the other device, remove the other device from the LAN, or temporarily connect the Diva 2430 directly to a computer (outside of the LAN).

The power light is blinking red.

•Press the Reset button on the device to resolve the problem.

•If the power light continues to blink, hold down the Reset button for 15 seconds to reset the device to factory defaults.

•If the light continues to blink red, contact your service representative.

Image 32

Contents Diva 2430 Adsl Modem Fourth Edition March 206-362-04 Contents Introduction This SectionSetup and Configuration Features Adsl and Network FeaturesHardware Features Introducing the Diva 2430 Adsl ModemPackage Contents Setup Connecting to Both Ports OverviewHardware Requirements Software RequirementsAbout Microfilters Connecting MicrofiltersConnecting the Microfilters USB Setup Windows 2000, or Windows MeProcedure Connect the CablesInstall USB Drivers Setup USB Setup Test Internet Access Ethernet Setup Adsl Test Internet Access Optional Install the Diva Assistant Setup Optional Install the Diva Assistant LAN Setup Setup LAN Setup Configuring Settings via the Web Interface Logging into the Web-based Configuration InterfaceUsing the Configuration Menus ATM Settings Adsl Settings TCP/IP Setup Windows 95/98 Windows NT Windows Macintosh Mac OS 8 or later Can’t access the web-based configuration interface TroubleshootingCan’t access the Internet Power light is blinking red Using your Diva About the Diva Assistant Launching the Diva AssistantSystem Tray Icon General TabTools Tab Diagnostic Log TabPerformance Tab Indicator Lights Resetting the Device Normal ResetReset Settings to Factory Defaults Boot Monitor ModeWeb-based Configuration Interface Web-based Configuration Interface Overview Starting the Web-based Configuration Interface Getting Help ‘Save’, ‘Reset Form’, and ‘Cancel’ Buttons‘Reset’ and ‘Logout’ buttons on the main menu Saving and restoring configuration files Backing up Configuration Files Opening to the Firmware MaintenanceUpgrading Firmware Retrieving Firmware from the Eicon Networks Web SiteUploading New Firmware Resetting to Factory Defaults Advanced Topics Security Automatic Log Out Erasing the system password System passwordSetting a Password Disable Inbound Server Requests Enabling this OptionIP Traffic Only Before you Begin Setting up a VPN with Windows 95 or WindowsVirtual Private Networking Setting up a VPN with Windows Advanced Topics Virtual Private Networking Advanced Topics Virtual Private Networking Dialing the VPN Specifications and Regulatory Information Specifications General SpecificationsSoftware and Firmware Specifications UBR CBR Regulatory Information FCC Part 68 Notice Regulatory Information for the United StatesDeclaration of Conformity Safety Notice Regulatory Information for Canada Regulatory Information for the European Union Safety Status TNV-3Power Consumption Index Index