Pitney Bowes DA900 manual Change parallel port settings using plus and minus keys

8.Connect to Your Computer (continued)

9.Connect to Power

10.Turn On the Printer

DA900 AddressRight™ Printer 4

A Special Note for DEC Computer Users:

1.	Hold F2 during bootup.
2.	Choose “advanced” and then “integrated peripherals”.	Setup
3.	Change parallel port settings (using plus and minus keys)
	to:
	Parallel Port: 378, IRQ7	-
	Parallel Port Mode: ECP-DMA1 or ECP-DMA3
		4
4.	Save settings.

1. Connect the female end of the power cord to the power receptacle located on the right side of the printer as shown below.

2.Plug the male end of the power cord into a grounded outlet. Avoid switched outlets and those that share circuits with machines that have heavy current demand such as air conditioners, refrigerators, etc.

Also, please review the safety information in Chapter 1— Introduction of this guide.

Once you've connected the cable, press the printer's power switch to the "l" (ON) position. The printer control panel should read: "Printer Offline."

SV60970-OG Rev. A 4-9