4.Adjust for Media Thickness
DA900 AddressRight™ Printer 5
The media thickness knob located on the front control panel (see below) sets the distance between the printheads and the material. This distance must vary according to the thickness of the material fed.
To adjust for media thickness:
1.Determine the correct thickness setting by printing a test piece with the knob in the middle position.
Turn the knob clockwise for thicker material, counterclock- wise for thinner material.
Media Thickness | Dial Setting | |
0.004 to 1/32" | 0 to 2 | |
1/32 to 1/8" | 2 to 3 | |
1/8 to 1/4" | 3 to 7 | |
1/4 to 3/8" | ||
7 to 10 | ||
|
| |
|
|
|
Media Thickness Knob | 5 | |
|
|
2.If the address on the test piece appears blurred or too light, lower the printhead (turn knob counterclockwise). If the address appears smeared, turn knob clockwise in small increments and continue testing until the printing is clear.