JAI TM-1400 operation manual Connector Pin Configurations, Pin Description

Page 6

Installation

recommends using a cooling fan to set up a positive air flow around the camera, and following the precautions below:

•Mount the camera on a large heat sink (camera bracket) made out of a conductive material such as aluminum.

•Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conducting material like plastic.

•Make sure the camera has enough open space around it to facilitate the free flow of air.

2.2.2Connector Pin Configurations

2.2.2 (a) 12-Pin Connector (TM-1400)

FIGURE 3. 12-Pin Connector on Rear Panel of Camera

The TM-1400 has a 12-pin Hirose connector for power input, serial communication, and signal integration. Pin #1 is Ground and Pin #2 is +12V DC. Other pins handle a number of input and output functions, as shown in Table 1 below.

TABLE 1. 12-Pin Connector (TM-1400)

1 9

28

10

3 11 12 7

4 5 6

Pin

Description

Pin

Description

1	GND (power)	7	VD In
2	+12V DC	8	Reserved
3	GND (analog)	9	HD In
4	Video Out	10	RXD (RS-232)
5	GND (digital)	11	Integration Control/ROI
6	VINIT In	12	TXD (RS-232)

2.2.2 (b) 12-Pin Connector (TM-1400CL)

The TM-1400CL has a 12-pin Hirose connector for power input and signal integration. Pin #1 is Ground and pin #2 is +12V DC. The pinout table is shown below. For the TM-1400CL, serial communication camera control is done via the MDR26 Camera Link connector on the rear panel of the camera.

TABLE 2. 12-Pin Connector (TM-1400CL)

Pin	Description	Pin	Description
1	GND (power)	7	VD in
2	+12V DC	8	Reserved
3	GND (analog)	9	HD in
4	Video out	10	N/C
5	GND (digital)	11	Integration Control/ROI
6	VINIT in	12	N/C

TM-1400 Series Progressive Scan Shutter Cameras