Page 11
Installation
2.2.6Camera Link Cable (CL Versions Only)
The MDR26 cable assembly (26CL-02-26) from 3M (part number 10226-6212VC) has been standardized as the Camera Link cable. This cable has the 26-pin MDR26 connector on both ends. This is a straight-through cable. The pin-out configuration is shown in Table 4 on page 8.
26 Position | | 26 Position |
High Density | Cable | High Density |
Mini D Ribbon | | Mini D Ribbon |
(MDR) Male Plug | | (MDR) Male Plug |
14 15 16 17 18 19 20 21 22 23 24 25 26
1 23 4 56 7 89 10 11 12 13
1 23 4 56 7 89 10 11 12 13
14 15 16 17 18 19 20 21 22 23 24 25 26
2X | 2X |
Thumbscrews | Thumbscrews |
Note: For TM-1400CL, serial communication for camera control is done via the Camera Link connector on the rear panel of the camera.
Cable assemblies and boardmount receptacles can be ordered from 3M.
2.2.7Power Supplies and Power Cable Setup
2.2.7 (a) Power Supplies
The TM-1400 requires 12V DC power that is obtained through the 12-pin connector located on the rear panel of the camera. JAI PULNiX recommends the following power supplies:
PD-12UU | 100-240V | AC/12V DC | 1.2A universal voltage power supply with |
| | | US plug |
PD-12UUP | 100-240V | AC | 1.2A universal voltage power supply with US plug |
| | | and 12-pin connector |
PD-12UE | 100-240V | AC/12V DC | 1.2A universal power supply with European plug |
PD-12UEP | 100-240V | AC/12V DC | 1.2A universal power supply with European plug and |
| | | 12-pin connector |
If you are providing power through the 12-pin connector, the PD-12UUP and PD-12UEP power supplies are available with the 12-pin mating connector already attached to the leads from the power supply. The PD-12UU or PD-12UE power supply can be connected to the JAI PULNiX power cable either directly or via a terminal strip.
TM-1400 Series Progressive Scan Shutter Cameras 
