JAI operation manual Installation Digital Output Cable TM-1400 only

Page 10

Installation

2.2.5Digital Output Cable (TM-1400 only)

Male

Female

17 1

31 16

20 1

25.0mm	37	19
1.00 in

78.74 in (2 meters)

The TM-1400 camera uses the cable 30DG-02 from JAI PULNiX as a digital output cable. This cable has a 31-pin AirBorn connector on the camera end and a 37-pin D-sub male connector on the other end. Contact your JAI PULNiX representative regarding availability of interface cables for specific frame grabber models. Pinout configuration for the digital cable is shown below.

FIGURE 6. Pinout Configuration for Digital Output Cable

FROM 31 PIN CONN		TO 37 PIN CONN		WIRE COLOR		FROM 31 PIN CONN)		TO 37 PIN CONN		WIRE COLOR
PIN 1	CLK+	PIN 1	CLK+	ORG	1RED	PIN 21	VD			PNK	1BLU
PIN 2	LDV+	PIN 2	LDV+	GRY	1RED	PIN 22	N/C	PIN 18	NC	ORG	2BLU
PIN 3	FDV+	PIN 3	FDV+	WHT	1RED	PIN 23	GND	PIN 23	GND	GRY	2BLU
PIN 4	GND	PIN 16	GND	YLW	1RED
PIN 5	HD			PNK	1RED	PIN 24	DØ-	PIN 27	DØ-	WHT	2BLU
PIN 6	INTEG	PIN 37	INTEG	ORG	2RED	PIN 25	D1-	PIN 28	D1-	YLW	2BLU
PIN 7	N/C			GRY	2RED	PIN 26	D2-	PIN 29	D2-	PNK	2BLU
PIN 8	DØ+	PIN 8	DØ+	WHT	2RED	PIN 27	D3-	PIN 30	D3-	ORG	3BLU
PIN 9	D1+	PIN 9	D1+	YLW	2RED	PIN 28	D4-	PIN 31	D4-	GRY	3BLU
PIN 10	D2+	PIN 10	D2+	PNK	2RED	PIN 29	D5-	PIN 32	D5-	WHT	3BLU
PIN 11	D3+	PIN 11	D3+	ORG	3RED	PIN 30	D6-	PIN 33	D6-	YLW	3BLU
PIN 12	D4+	PIN 12	D4+	GRY	3RED	PIN 31	D7-	PIN 34	D7-	PNK	3BLU
PIN 13	D5+	PIN 13	D5+	WHT	3RED
PIN 14	D6+	PIN 14	D6+	YEL	3RED
PIN 15	D7+	PIN 15	D7+	PNK	3RED			PIN 35	GND	SHIELD
PIN 16	NC		NC
PIN 17	CLK-	PIN 20	CLK-	ORG	1BLU			N/C
PIN 18	CDV-	PIN 21	LDV-	GRY	1BLU			PINS 4, 5, 6, 7
PIN 19	FDV-	PIN 22	FDV-	WHT	1BLU			19, 24, 25,26,
PIN 20	VINIT	PIN 17	VINIT	YEL	1BLU			AND 36

TM-1400 Series Progressive Scan Shutter Cameras