JAI TM-1400 Installation Attaching the Analog Video Output, Attaching the Camera Lens

Page 20

Page 13

Installation

2.2.8Attaching the Analog Video Output

When connecting the TM-1400 to an analog frame grabber or a multisync monitor, use the BNC connector on the rear panel of the camera. The input of the monitor should be balanced for 75 ohms termination. Standard RG-59 type coaxial cable should carry a full video signal for up to 100 feet.

The multi-conductor cable 12P-02S from JAI PULNiX can be used to transmit analog video, power, sync. signals, and serial communication. The mini coaxial leads in JAI PULNiX multi-conductor cables are designed for short runs of no longer than 100 feet.

Note: Make sure that no extraneous wires are visible which could cause a short.

2.2.9Attaching the Camera Lens

The TM-1400 camera accepts 1/2" or larger format size C-mount lenses. To attach the C-mount lens to the camera, carefully engage the threads and rotate the lens clockwise until it firmly seats on the mounting ring. Do not force the lens if it does not seat properly. Please note that some lenses with extremely long flangebacks may exceed the mounting depth of the camera.

TM-1400 Series Progressive Scan Shutter Cameras

Image 20

Contents TM-1400 Series Progressive Scan Shutter Cameras CE Compliance JAI PULNiX, IncPage Installation Table of ContentsTroubleshooting TM-1400 System Configuration List of FiguresList of Tables Product Description May 2Features IntroductionIntegration WarrantyFunctional Options System Configuration TM-1400 System ConfigurationCamera Setup Getting StartedConnector Pin Configurations Pin DescriptionPin # Description LDVSerToFG Differential Serial Communication to frame grabber Installation 4 RS-232 Communication Cable TM-1400 only Shutter Speed Control Dial TM-1400 onlyShutter Exposure Time Seconds Normal AsyncInstallation Digital Output Cable TM-1400 only Pinout Configuration for Digital Output CableInstallation Camera Link Cable CL Versions Only Power Supplies and Power Cable Setup02S Interface Cable optional Installation Attaching the Analog Video Output Attaching the Camera LensCamera Rear Panel TM-1400 Mode Selection Switch Progressive Scanning Power and External Sync ConnectorCamera Rear Panel CL Versions External Vinit With Pulse Width Asynchronous ResetElectronic Shutter No-Delay Shutter Internal Shutter Speed ControlDynamic Range Control Programmable Look-Up Table LUT and Knee ControlScan Modes External SyncBayer Color Filter Color Versions Full Progressive ScanOperation Color Filter Array Bayer Color Filter Array CFAOperation Starting Pixel Configuration Sync and DataCamera Functions FDVManufacturer Frame Grabber Software Operation Interpolation SoftwareColor Interpolation Camera Timing Charts Tcc =14 nsec, Tdc = 6 nsec, Thd = 5 nsec Horizontal SignalsAsync Shutter Reset Timing Operation Mode 15 Frame /sec Async Shutter Reset Timing Async Shutter Reset Timing Partial Scan 500 Lines Async Shutter Reset Timing Partial Scan 250 Lines Serial Communication Kit CS-232C not required for CL version Problems and Solutions TroubleshootingSymptom No Video Symptom Dark VideoInformation and Support Resources Model TM-1400 series SpecificationsAppendix Physical Dimensions Effective Image AreaPhysical Dimensions TM-1400CL Spectral ResponseW . j a i p u l n i x . c o m