JAI TM-1400 Electronic Shutter, Asynchronous Reset, External Vinit With Pulse Width

Page 24

Page 17

Operation

The TM-1400 outputs the progressive scan image with an electronic shutter in two different formats:

Progressive scanning digital and analog output

The CCD signal goes through A/D and D/A converters and through 10-bit in, 8-bit out look-up table (LUT). The digital output is available from 31-pin connector with RS-644 format (50MHz clock rate).

The analog output is the same as 75 ohms, 1Vp-p format at 30Hz rate available from BNC and 12- pin connector.

Partial scan output (display output)

-Partial scan: 500 lines at 56 frames per second.

-Partial scan: 250 lines at 98 frames per second.

Note: Minimal blooming may occur under partial scanning mode due to the nature of the CCD.

3.4 Electronic Shutter

For more information about the electronic shutter, please see Section 1.2 on page 2.

3.5 Asynchronous Reset

ASYNC RESET

VINIT

VD

TG (TRANSFER GATE)

DISCHARGE PULSE

PROGRESSIVE OUTPUT

VIDEO

Stand-by Image

Shutter Video

Stand-by Image

For more information about Asynchronous Reset, please see Section 1.2 on page 2.

3.5.1External VINIT With Pulse Width

The TM-1400 can be reset with external reset pulse (VINIT). Set the dial switch to “9”. Apply a pulse- width control VINIT signal generated from an external event trigger to the camera. The internal reset pulse will be latched to HD and at the first HD timing from the external pulse leading edge (negative going edge). The CCD discharge pulse will be generated to clear the images. The internal VD will be generated at the following edge (positive going edge) of the external pulse, resetting the internal timing including the video sync. The shutter speed is the same as the external pulse width, but the integration delays 1H from the leading edge. For the immediate reset option, please contact JAI PULNiX.

For the progressive format, one frame of video output will start from the rising edge of the pulse width control. In async mode with external pulse input high, the video output will be disabled as the camera continues discharging the CCD image, providing black video only.

TM-1400 Series Progressive Scan Shutter Cameras

Image 24
Contents TM-1400 Series Progressive Scan Shutter Cameras CE Compliance JAI PULNiX, IncPage Installation Table of ContentsTroubleshooting TM-1400 System Configuration List of FiguresList of Tables Product Description May 2Features IntroductionWarranty Functional OptionsIntegration System Configuration TM-1400 System ConfigurationCamera Setup Getting StartedConnector Pin Configurations Pin DescriptionPin # Description LDVSerToFG Differential Serial Communication to frame grabber Installation 4 RS-232 Communication Cable TM-1400 only Shutter Speed Control Dial TM-1400 onlyShutter Exposure Time Seconds Normal AsyncInstallation Digital Output Cable TM-1400 only Pinout Configuration for Digital Output CableInstallation Camera Link Cable CL Versions Only Power Supplies and Power Cable Setup02S Interface Cable optional Installation Attaching the Analog Video Output Attaching the Camera LensCamera Rear Panel TM-1400 Mode Selection Switch Power and External Sync Connector Camera Rear Panel CL VersionsProgressive Scanning Asynchronous Reset Electronic ShutterExternal Vinit With Pulse Width No-Delay Shutter Internal Shutter Speed ControlDynamic Range Control Programmable Look-Up Table LUT and Knee ControlScan Modes External SyncBayer Color Filter Color Versions Full Progressive ScanOperation Color Filter Array Bayer Color Filter Array CFAOperation Starting Pixel Configuration Sync and DataCamera Functions FDVOperation Interpolation Software Color InterpolationManufacturer Frame Grabber Software Camera Timing Charts Tcc =14 nsec, Tdc = 6 nsec, Thd = 5 nsec Horizontal SignalsAsync Shutter Reset Timing Operation Mode 15 Frame /sec Async Shutter Reset Timing Async Shutter Reset Timing Partial Scan 500 Lines Async Shutter Reset Timing Partial Scan 250 Lines Serial Communication Kit CS-232C not required for CL version Problems and Solutions TroubleshootingSymptom No Video Symptom Dark VideoInformation and Support Resources Specifications AppendixModel TM-1400 series Physical Dimensions Effective Image AreaPhysical Dimensions TM-1400CL Spectral ResponseW . j a i p u l n i x . c o m