Installation and Setup ida ReRouter
NOTE: LU Alias must match the LU Alias defined in
Communications Manager
If the LU Alias is not defined, the idaRoute will terminate and write to the log file.
6. Enter IP Address (in Decimal Dot notation)
NOTE: Must match the device (e.g. ida
Range: 0.0.0.0 - 255.255.255.255.
Default: None
7.Select Port No.
NOTE: This is default 5001 for all IPDS applications
Range: Decimal value
Default: 5001 *)
*): Remote devices supporting more than one output port may use port no. 5002. For details you are referred to the manual for the remote device being connected to.
8.Enter Connect Timeout
This entry field will specify the time the idaRoute will wait after
having initiated a connection till the idaRoute receives a response from the remote TCP/I P attached device.
Range:
Default: 30 seconds.
9.The field Trace Class is used for debugging purposes only.
For additional information, see chapter 9: "Problem Determination"
10.Click on "OK" to verify the configuration.
19