HotBrick Network Solutions
Rear Panel VPN 800/2 Firewall Router
Figure 1-3: Rear Panel VPN 800/2 Firewall Router
AC power socket
Connect the supplied power here.
Default Settings
When the VPN 800/2 Firewall Router has finished booting, all configuration settings will be set to the factory defaults, including:
•IP Address set to its default value of 192.168.1.1, with a Network Mask of 255.255.255.0
•DHCP Server is enabled
•User Name: admin
•Password cleared (no password)
TFTP Download
This setting should be used only if your VPN 800/2 Firewall Router is unusable, and you wish to restore it by downloading new firmware. Follow this procedure:
1.Power On the VPN 800/2 Firewall Router.
2.Use the supplied Windows utility or a TFTP client program applies the new firmware. If using the supplied Windows TFTP program, the screen will look like the following example.
Figure 1-4: Windows TFTP utility VPN F 800/2 Firewall Router
•Enter the name of the firmware upgrade file on your PC, or click the "Browse" button to locate the file.
•Enter the LAN IP address of the VPN 800/2 Firewall Router in the "Server IP" field.
•Click "Download" to send the file to the VPN 800/2 Firewall Router.
3.When downloading is finished. It should then work normally, using the default settings.
Page 6