HotBrick VPN 800/2 manual Settings Multi DMZ

	HotBrick Network Solutions
Settings – Multi DMZ
Enable	Use this to enable or disable the DMZ setting, as required.
Name	Enter a name to assist you to remember this setting. This name has no effect
	on the operation.
For Static IP
Public IP address	Enter the WAN port (Internet) IP address you wish to associate to a PC. This
	IP address must have been allocated to you by your ISP.
Private IP	Enter the IP address of the PC you wish to associate with this WAN port IP
Address (LAN)	address. This IP address should be fixed, or reserved. (See the Host IP
	section for details on reserving an IP address.)
For Dynamic IP
WAN	Select the desired WAN port.
Session	• Select "DHCP" if the IP address on this WAN port is dynamically
	assigned. You can only select assign one (1) Private (LAN) IP address to
	each port.
	• If using multi-session PPPoE, select the desired PPPoE session. These
	sessions are defined on the Advanced PPPoE screen. You can assign
	one (1) one (1) Private (LAN) IP address to each PPPoE session.
Private IP	Enter the IP address of the PC you wish to associate with this WAN port IP
Address (LAN)	address. This IP address should be fixed, or reserved. (See the Host IP
	section for details on reserving an IP address.)
Access Group	You can decide the users to have the authority of using DMZ, by define the
	groups.
Direction	For DMZ, you can allow inbound, outbound only, or both inbound and
	outbound both.

Page 38