GD Commerce EDA-M100, EDA-M300, EDA-M350, EDA-M200, EDA-M150, Control and Booster Panels Windmill

Page - 8 Windmill￿

Alert When Alert is pressed on the corresponding panel the sounder circuits, auxiliary relays and radio￿ sounders operate as programmed. For a more detailed description of the sounder circuits, auxiliary relays￿ and radio sounders see the device programming section (5.4.1) Relay operation silence alarm When Reset￿ is pressed on the fire alarm panel any auxiliary relays that have been programmed to operate in a fire￿ alarm condition will cancel. In order to cancel these when ‘Silence Alarm’ is pressed the appropriate￿ auxiliary box can be checked.￿

Fault Aux. Relay In the event of a common fault condition a relay can be programmed to operate by check-￿ ing the appropriate relay box. The system defaults to Aux. 2 operating on a fault condition. Aux. 2 is a fail-￿ safe relay. The relay is normally closed in normal operation and will open in either a fault condition or a￿ power supply failure.￿

5.6 Change System Settings￿

To change the global system settings click in ‘Change System Settings’ and figure 5.6 will be displayed￿

Each field is detailed below.￿

Customer Name The customer name appears in the top line of the LCD of both the EDA-M100 and EDA-￿ M200 control panels in system normal or fault mode. This should be entered using a maximum of 17 char-￿ acters.￿

Customer Telephone Number This phone number appears on the second line of the LCD on both the EDA-￿ M100 and EDA-M200 control panels in a system normal and fault mode. This should be a maximum of 12￿ characters.￿

Time Until Verify Fail This value is the time in minutes before a fault is displayed detailing a lost device on￿ the system. 270 minutes is the implied by the BS 5839 standard.￿

Logon Signal Strength The minimum signal strength required for the system to allow a device to logon on.￿ Devices only. EDA-M100 range only.￿

System 1-7,8-15 System numbers are set using the dip switches on the panel. Some systems require using systems higher than 7 and require setting here. Note Analogue systems should not be set to system num-￿ bers 8-15.￿

Display Internal Fail NOT IMPLEMENTED￿

GD Systems