FujiFilm MP-300 Loading the photo pack, Photo pack confirmation window, Open the photo pack door

Page 12

Getting Ready to Print

Loading the photo pack

1 2

Turquoise mark inside the printer

Turquoise mark on the photo pack

Lit (POWER button)

1 Open the photo pack door.

While holding down button 1, slide knob 2 in the direction of the arrow.

2 Loading the photo pack.

Hold the pack by the sides and drop it straight in. Never press on the 2 rectangular holes in the back.

3 Close the photo pack door.

When closing the photo pack door, press the door until click shut.

4 Turning on the power.

Hold down the POWER button (one second or more) to turn the printer on.

Photo pack confirmation window

This window allows you to check whether there is a photo pack loaded into the printer.

Photo pack loaded

Nophoto pack

Photo pack care

The film is sensitive to light and dust. Light inside the photo pack may expose the film, causing incorrect printing of images. Also, any dust inside the photo pack or printer may scratch the film. Always observe the following precautions when using photo packs.

! Avoid exposure to light.

zAvoid exposure to direct sunlight when loading the photo pack.

zNever press on the 2 rectangular holes in the back.

zStopping midway or re-opening the door before it is fully closed risks exposing the photos.

Getting Ready

Blinking (5 sec.)

Turn off (11 sec.)

22

x The first time the printer is turned on after photo pack is loaded, the printer performs internal printing preparations. The printer receives data while the motor is running and printing starts when preparation is completed.

x When the POWER button lights and “10” appears on the film counter, the printer is ready to print.

! Avoid exposure to dust.

zAvoid exposure to dust when loading the photo pack.

zDo not remove the photo pack’s inner packaging until just before loading it directly into the printer.

23

Image 12 Contents
Getting Ready Printing Advanced Printing Error Features Easy printing of beautiful printsContents Quick Start Guide Infrared communication Quick Start Guide PictBridgeIntroduction About IrSimpleSafety Precautions Disconnect the AC power adapterUnstable substances which can give off dangerous vapors Handling & Care Printer careNever attempt to take this product X apart Never get this product wet or handle it C with wet handsUsing USB interface Using the AC power adapterPhoto pack and print care Handling & CareRestrictions Finishing printsDo not put in the mouth. Do not cut Do not pull apart Optional AC Power Adapter AC power adapter AC-5VX sold separately P.14Necessary Items BatteriesOpen the battery cover Loading the batteries Close the battery coverPart Names Getting Ready to PrintLoading the photo pack Photo pack confirmation windowOpen the photo pack door Close the photo pack doorSetting up for infrared transmissions Printing Infrared communicationPrinting Sending images from a camera phone Select the image on the mobile phoneSelect infrared transmission Recommended image sizes for transmissionSetting up for USB transmissions Select PictBridge in the digital camera’s USB settingTake the film out when film output ends Printing PictBridgeWhen all the specified images If 2 or more prints are set at the cameraTurn the printer off Press the Reprint buttonSupported print Specifications Additional Information and Notes on PrintingPictBridge print specification compatibility table Printable image sizes and formatsWhen the Film Runs Out When the film runs out while printingCheck that the film counter shows Remove the photo packErasing the stored image Check that the printer is turned onCheck that the printer is turned off Sharpen Mode Date Mode Press the Sharpen buttonPress the Date button Error Error lamp When PictBridge is usedDate printing position Blinking 3 timesError LOW Battery lamp TroubleshootingTroubleshooting printer problems LitTroubleshooting infrared communication problems TroubleshootingTroubleshooting USB communication problems Troubleshooting problems with finished prints GlossarySpecification JpegSpecification About Mobile Printing Ready Products