FujiFilm MP-300 owner manual Introduction, About IrSimple

Introduction

Contents of package

1, Lithium Batteries	2, Owner’s Manualc	3, Mobile Printer
(CR2)		MP-300
(P.18)
		Getting Ready
		Printing
		Advanced Printing
	The owner’s manual	Error
	en: The owner’s manual in English and French is available at “http://home.fujifilm.
	com/products/dmp.”
	fr: Le manuel d’utilisation en Anglais et en Français est disponible sur le site
	“http://home.fujifilm.com/products/dmp.”
	FPT-608106-FP-01

c The design of the cover page of Owner’s manual may differ depending on the regions.

zIrSimple™, IrSimpleShot™ and IrSS™ are trademarks of the Infrared Data Association®.

z“ ” and Image Intelligence™ are trademarks of Fuji Photo Film Co., Ltd.

zAll other company, organization or product names used in this document are trademarks or registered trademarks of their respective holders in Japan or other countries. Note that the ™ and ® symbols may be omitted in some instances in this document.

8

About IrSimple™

■What is IrSimple™?

IrSimple™ is a high-speed infrared communication protocol that permits high-speed data transfer. It was adopted in August 2005 as an international standard by the IrDA® (Infrared Data Association®), which is the standardization body for infrared technology.

IrSimple uses the same physical interfaces (SIR/FIR) as the existing IrDA standard and has the following 2 communication modes:

zUnidirectional

In this mode, data is only sent in one direction: from the sending device (primary node). Problems that arise during communication cannot be corrected.

zBidirectional

This is a bidirectional mode in which the receiving device (secondary node) responds to data sent from the sending device (primary node) by sending the outcome of the data reception or requesting a resend, etc. This allows problems that arise during communication to be corrected.

■What is IrSimpleShot™ (IrSS™)?

This is a generic name given to unidirectional IrSimple™ communication.

■IrSimple™ compatibility on the MP-300

The MP-300 supports both IrSimpleShot communication mode and bidirectional communication mode.

■Restrictions on IrSimple™ on the MP-300

zThe MP-300 can only operate as a receiving device (secondary node). zThe MP-300 will only receive IrSimpleShot communication from a sending

device equipped with a high-speed infrared communication function (FIR). (The MP-300 does not support IrSimpleShot communication using SIR.)

zWhen a sending device equipped with a high-speed infrared communication function (FIR) uses FIR to make an IrSimpleShot transmission to the MP-300, the MP-300 can only receive data up to 1 MB in size. (It cannot receive files larger than 1 MB.)

Note also that, depending on the transmission conditions (transmitted packet size, etc.), the MP-300 may be unable to receive data from a sending device even if it meets the above requirements.

■ IrSimple™ transmission speed

zSee “Guide to image sizes and transmission times” on P.27. 9