Printing PictBridge | FujiFilm MP-300 manual

PRINTING - PictBridge -

Setting up for USB transmissions

On some digital camera models, the digital camera should be turned on at this point. Check the owner’s manual for your digital camera.

		PI CT BR IDGE
	1	ENGLISH
		SET
	2
		NTSC
	3
		OK

Select PictBridge in the digital camera’s USB setting.

x For information on using your digital camera, refer to the owner’s manual supplied with the camera.

	Lit Blinking	2 Select the image on the digital
	Lit Blinking	camera and then print the image.
		camera and then print the image.
		x The POWER button blinks slowly

Connect the digital camera to the printer.

x When the printer and the digital camera are correctly connected, the PictBridge lamp will light after MP-300 power on.

during image transfer.
x For information on using your digital	Printing
camera, refer to the owner’s manual
supplied with the camera.
x If multiple prints have been speciﬁed,
refer to P.31.

x Use the USB cable supplied with the digital camera. Do not use an extension cable or USB hub.

x The location of the USB socket varies depending on the digital camera used.

On some digital camera models, the digital camera should be turned off at this point. Because the transmission method varies depending on the model used, check the owner’s manual for your digital camera.

Printing

	1 Turning on the power.
Lit	Hold down the POWER button (one
	second or more) to turn the printer on.
	x The POWER button lights.
	x If you leave the printer on, it automatically
	turns off (after 3 minutes when using
	batteries and after 10 minutes when
	using the AC power adapter).
	Check the ﬁlm counter to ensure that
28	there is still ﬁlm in the printer.

Lit (PictBridge lamp)

Rapid Blinking (POWER button)

Lit (PictBridge lamp)

Lit (POWER button)

The film is fed out roughly 20 seconds after the printer receives the image.

x The POWER button blinks rapidly during printing.

x Printing of a VGA-size (FUJIFILM standard) image takes 20 seconds once the infrared signal is received.

x Printing may take longer for images larger than VGA-size.

3 Take the film out when film output ends.

Take the print out when the POWER button stops blinking and stays lit.

x When the POWER button stops blinking and stays lit, the next image can be transferred.

xSee “Notes on taking out ﬁlm”. (P.25)