FujiFilm MP-300 Quick Start Guide Infrared communication, Quick Start Guide PictBridge

Page 4

Quick Start Guide - Infrared communication -

1 Loading the batteries.	2 Loading the photo pack.
(P.21)	(P.22)
	Turquoise mark inside
	the printer
	Turquoise mark on
	the photo pack

Quick Start Guide - PictBridge -

1 Loading the batteries.	2 Loading the photo pack.
(P.21)	(P.22)
	Turquoise mark inside
	the printer
	Turquoise mark on
	the photo pack

3 Turning on the power.

Lit

Hold down for

1 second or more.

4 Send the image.

(P.24)

20cm (7.9 in.)

15˚ 15˚

Slow Blinking (POWER button)

3 Connect the printer to the digital camerac. (P.28)

4 Turning on the power.

Lit

Hold down for

1 second or more.

5 Take the film out when film output ends. (P.25)

c Before connecting the printer, select PictBridge mode in the camera’s USB setting, if needed.

Lit (POWER button)

5 Send the image from the		6 Take the film out when film
digital camera. (P.29)		output ends. (P.25)
		Lit (PictBridge lamp)
Lit	Blinking
	Blinking

6	Lit (POWER button)	7

Image 4

Contents Getting Ready Printing Advanced Printing Error Features Easy printing of beautiful printsContents Quick Start Guide Infrared communication Quick Start Guide PictBridgeIntroduction About IrSimpleDisconnect the AC power adapter Safety PrecautionsUnstable substances which can give off dangerous vapors Handling & Care Printer careNever attempt to take this product X apart Never get this product wet or handle it C with wet handsUsing USB interface Using the AC power adapterPhoto pack and print care Handling & CareFinishing prints RestrictionsDo not put in the mouth. Do not cut Do not pull apart Optional AC Power Adapter AC power adapter AC-5VX sold separately P.14Necessary Items BatteriesOpen the battery cover Loading the batteries Close the battery coverPart Names Getting Ready to PrintLoading the photo pack Photo pack conﬁrmation windowOpen the photo pack door Close the photo pack doorPrinting Infrared communication Setting up for infrared transmissionsPrinting Sending images from a camera phone Select the image on the mobile phoneSelect infrared transmission Recommended image sizes for transmissionSetting up for USB transmissions Select PictBridge in the digital camera’s USB settingTake the film out when film output ends Printing PictBridgeWhen all the specified images If 2 or more prints are set at the cameraTurn the printer off Press the Reprint buttonSupported print Specifications Additional Information and Notes on PrintingPictBridge print speciﬁcation compatibility table Printable image sizes and formatsWhen the Film Runs Out When the ﬁlm runs out while printingCheck that the film counter shows Remove the photo packCheck that the printer is turned on Erasing the stored imageCheck that the printer is turned off Press the Sharpen button Sharpen Mode Date ModePress the Date button Error Error lamp When PictBridge is usedDate printing position Blinking 3 timesError LOW Battery lamp TroubleshootingTroubleshooting printer problems LitTroubleshooting infrared communication problems TroubleshootingTroubleshooting USB communication problems Troubleshooting problems with finished prints GlossarySpeciﬁcation JpegSpeciﬁcation About Mobile Printing Ready Products