DATE Mode
ERROR - ERROR lamp -
When PictBridge is used
Set date mode on the digital camera.
x For information on setting date mode on your digital camera, refer to the owner’s manual for the camera.
Lit (Approx. 7 sec. → Power off)
Lit
Operating temperature too high or too low.
Only use between +5°C and +40°C (+41°F and +104°F).
◆ When the ERROR lamp lights ◆
Take the measures described below to restore printer operation. <Operating temperature too low>
Date printing position
2006.06.06 | 2006. |
2006.06.06
Use the printer at +5°C (+41°F) or higher or warm the printer at body temperature for around 10 minutes. <Operating temperature too high>
Use the printer at +40°C (+104°F) or lower or move the printer to a cool location.
06.06 |
Blinking (3 times)
Case 1. Cannot print transferred data.
2006.06.06
◆ When an image with no date information is sent ◆
Blinking (3 times)
Check image size/format. (P.9, 33)
x If a Progressive JPEG image is sent, the POWER button may blink.
Blinking (7 times)
Blinking (3 times)
If date mode is selected and the image sent has no date information or has date information that is not EXIF data, the ERROR lamp blinks 3 times, the DATE lamp blinks 7 times at the same time and the image cannot be printed. Cancel date mode and then resend the image or send a different image.
Blinking (7 times)
Blinking 
(3 times)
Case 2. No stored image for “Reprint”.
Transfer an image.
Date mode error
See “When an image with no date information is sent”. (P.40)
x The date printed is the date included in the transmitted data.
x If the image has been edited (such as by adding a frame after the picture was taken), the image’s recorded date may be overwritten.
x Date mode supports
x The printed date may be difficult to see against some backgrounds. The date color cannot be changed.
x Date information that was added by a sending device may not be printed
40correctly.
Blinking 
(3 times)
Lit
Error
PictBridge communication error
See “Troubleshooting USB communication problems”. (P.46)
41