FujiFilm MP-300 owner manual Troubleshooting USB communication problems

Troubleshooting

Problems	Possible Causes	Solutions
The POWER button	3 The sending device	3 Send the data from a
changed from	is not compatible with	compatible device.
blinking to lit during	the printer.
data transfer and
nothing was printed.

■Troubleshooting USB communication problems

Problems	Possible Causes	Solutions
The print menu does	1 The digital camera	1 Use a PictBridge
not appear on the	is not a PictBridge	supported digital
digital camera.	supported model.	camera.
	2 PictBridge is not	2 Change the digital
	selected in the	camera’s USB setting
	digital camera’s USB	to PictBridge mode.
	setting.
	3 The USB cable is not	3 Check the USB cable
	connected correctly.	connections.
	4 The power of MP-300	4 Power on MP-300.
	is off.
The PictBridge lamp	The USB cable is not	Check the USB cable
does not light.	connected correctly.	connections.
The printer won’t	Data reception from the	To shorten data transfer
start printing. (The	digital camera takes	times, use small image
POWER button	some time because the	sizes (around 640 × 480
doesn’t start blinking	image is large.	pixels) for your shots.
rapidly.)		(P.32)
The POWER button	The device sending the	Send the data from a
changed from	data is not compatible	compatible device.
blinking to lit during	with the printer.
data transfer and
nothing was printed.

46

Problems	Possible Causes	Solutions
Error sign appears	1 There was a fault of	1 Turn the digital
on the camera.	some kind during	camera and the
	USB communication.	printer off and then
		back on again.
	2 The printer is not	2 Turn the printer on.
	turned on.
	3 The printer is out of	3 Load a new photo
	film.	pack.
The ERROR lamp	1 An error occurred	1 Resend the images.
blinks (3 times).	during data transfer.
	2 The image sent	2 The maximum
	exceeds the	number of pixels
	maximum number of	(image size)
	pixels supported by	supported by the
	the printer.	printer is [6400 ×
		6400 pixels].
When I send multiple	The interval between	1 Press the REPRINT
images one at a	transmissions is 5	button.
time, the second and	seconds or less.	2 When sending
subsequent images		images one at a time,
are not printed. (The		leave an interval of
PictBridge lamp is		at least 5 seconds
blinking.)		between images.

47