FujiFilm MP-300 If 2 or more prints are set at the camera, Turn the printer off, Recommended

Page 16

PRINTING - PictBridge -

4

Turn the digital camera off and then disconnect the USB cable.

If 2 or more prints are set at the camera

If 2 or more prints have been specified, take the film out after the first image has been printed and then proceed as described below.

Turn off

5

x

Turn the printer off.

If you are using the AC power adapter, turn the printer off before disconnecting the adapter.

1

BlinkingLit

2

x

Check that the POWER button is lit and that the PictBridge lamp is blinking.

Press the REPRINT button.

When the PictBridge lamp is blinking, pressing the REPRINT button prints the next selected image.

Printing

3 Take the film out when film output ends.

◆ Recommended ◆

x If the ﬁlm counter decrements to “0” while the speciﬁed images are being

The use of an AC power adapter (optional AC-5VX) is recommended for printing via USB communication. (P.19)

Lit (POWER button)

printed, see “When the ﬁlm runs out while printing”. (P.35)

x Do not disconnect the USB cable or AC power adapter or turn the power off until printing has ﬁnished.

x The location of the digital camera’s USB socket, its image transmission procedures and operation procedures all differ depending on the camera

30model used. Refer to the owner’s manual for your camera.

Repeat steps 1 to 3 until all the images have been printed.

Lit	Lit	When all the specified images
		have been printed, the PictBridge
		lamp stops blinking and stays lit.

x Do not disconnect the USB cable or AC power adapter or turn the digital camera off until all the images have been printed.

31

Image 16

Contents Getting Ready Printing Advanced Printing Error Features Easy printing of beautiful printsContents Quick Start Guide Infrared communication Quick Start Guide PictBridgeIntroduction About IrSimpleDisconnect the AC power adapter Safety PrecautionsUnstable substances which can give off dangerous vapors Handling & Care Printer careNever attempt to take this product X apart Never get this product wet or handle it C with wet handsUsing USB interface Using the AC power adapterPhoto pack and print care Handling & CareFinishing prints RestrictionsDo not put in the mouth. Do not cut Do not pull apart Optional AC Power Adapter AC power adapter AC-5VX sold separately P.14Necessary Items BatteriesOpen the battery cover Loading the batteries Close the battery coverPart Names Getting Ready to PrintLoading the photo pack Photo pack conﬁrmation windowOpen the photo pack door Close the photo pack doorPrinting Infrared communication Setting up for infrared transmissionsPrinting Sending images from a camera phone Select the image on the mobile phoneSelect infrared transmission Recommended image sizes for transmissionSetting up for USB transmissions Select PictBridge in the digital camera’s USB settingTake the film out when film output ends Printing PictBridgeWhen all the specified images If 2 or more prints are set at the cameraTurn the printer off Press the Reprint buttonSupported print Specifications Additional Information and Notes on PrintingPictBridge print speciﬁcation compatibility table Printable image sizes and formatsWhen the Film Runs Out When the ﬁlm runs out while printingCheck that the film counter shows Remove the photo packCheck that the printer is turned on Erasing the stored imageCheck that the printer is turned off Press the Sharpen button Sharpen Mode Date ModePress the Date button Error Error lamp When PictBridge is usedDate printing position Blinking 3 timesError LOW Battery lamp TroubleshootingTroubleshooting printer problems LitTroubleshooting infrared communication problems TroubleshootingTroubleshooting USB communication problems Troubleshooting problems with finished prints GlossarySpeciﬁcation JpegSpeciﬁcation About Mobile Printing Ready Products