Dell XFR D630 service manual Memory module Dimm a

DellTM XFR D630 Fully Rugged Notebook Service Manual

1 memory module (DIMM A)

2 securing clips (2)

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.

4.If you are replacing a memory module, ground yourself and remove the existing module:

a.Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

b.Remove the module from the connector.

1 securing clips (2) 2 memory module

5.Ground yourself and install the new memory module:

a.Align the notch in the module connector with the tab in the connector slot.

b.Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

Page 52 of 106 Revision A01