DellTM XFR D630 Fully Rugged Notebook Service Manual
The stylus clip is installed on the handle assembly’s end screw on the left or right side of the notebook. The stylus clip provides an eyelet into which the stylus tether can be routed to attach the stylus and stylus tether to the notebook
1
Handle cover
2
Stylus clip
3
Screw
Close Up View of Installed Stylus Clip
CAUTION: Care is needed when installing this clip. The clip is installed with the raised part towards the center of the notebook so that the raised part of the clip is within the recessed area of the handle cover. If the clip is installed the opposite way, this raised metal part of the clip is now above the handle cover housing, and you can easily cut or injure yourself.
To replace the stylus clip:
1.Loosen the screw on the end of the handle cover that secures the stylus clip. Note that the stylus clip can be installed on the end of either handle cover to allow for right or
2.Slide the old stylus clip from beneath the loosened screw.
3.Slide the new stylus clip between the handle cover and the screw.
Page 18 of 106 | Revision A01 |