Datamax DGL STX a Set Time and Date, STX a Enable Feedback Characters, STX e Select Edge Sensor

2 Fully Supported

Commands

System-Level Command Functions

STX A - Set Time and Date

This command sets the time and date. The initial setting of the date will be stored in the printer’s internal memory. This date can be verified by printing a configuration label.

STX a - Enable Feedback Characters

This command enables the feedback ASCII HEX characters 07, 1E, and 1F to be returned from the printer following specific events.

STX B - Get Printer Time and Date Information

This command retrieves the time and date information from the printer and transmits the response to a host device. See <STX>A for details and restrictions.

STX c - Set Continuous Paper Length

This command is used to define the page (label) size when printing on continuous media. It disables the media sensor top-of-form function but continues to monitor paper-out conditions.

STX E - Set Quantity For Stored Label

This command sets the number of labels to print for the label format currently stored in the print buffer. (The printer automatically stores the most recent label format in the buffer until the printer is reset or turned ‘Off’.) To print, this command is used in conjunction with the <STX>G command.

STX e - Select Edge Sensor

This command enables “see-through” sensing for top-of-form detection of die- cut and notched media. The printer’s transmissive media sensor will detect a minimum gap of 0.05 inches (1.27mm) between labels. Label stock must be at least 0.1 inches (2.5mm) between each top-of-form (start of print point on the next label).

17