Cobalt Networks 9084 manual Installation and Setup, Installing a Rear I/O Module

Installation and Setup Installing a Rear I/O Module

Note: To remove a card, press down on the ejector tab to unseat the card from the rear I/O module mating connector. Evenly draw the card from its slot.

10.If network remote control is to be used for the frame and the frame has not yet been set up for remote control, perform setup in accordance with Setting Up 9084 Network Remote Control (p. 2-4).

Note: If installing a card in a frame already equipped for, and connected to DashBoard™ , no network setup is required for the card. The card will be dis- covered by DashBoard™ and be ready for use.

Both the built-in Rear I/O Modules on the 8310-BNC/

8310-C-BNC frames and the optional RM-9084-A Rear I/O Module use the connector arrangements shown to the left.

Connect cabling as shown. Unused connectors do not require external termination.

Figure 2-1 9084 Rear I/O Module Connections

Installing a Rear I/O Module

Note: This procedure is applicable only if a Rear I/O Module is not currently installed in the slot where the 9084 is to be installed.

If installing the 9084 in a 8310-C-BNC or 8310-BNC frame (which is pre-equipped with a 100-BNC rear I/O module installed across the entire backplane) or a slot already equipped with a suitable I/O module, omit this procedure and go to Installing the 9084 Into a Frame Slot (p. 2-1).

Install a Rear I/O Module as follows:

1.On the 8310 frame, determine the slot in which the 9084 is to be installed.

2.In the mounting area corresponding to the slot location, install Rear I/O Module as shown in Figure 2-2.

9084-OM (V4.0) 9084 PRODUCT MANUAL 2-3