Operating Instructions | Troubleshooting |
9084 Processing Error Troubleshooting
Table
In the majority of cases, most errors are caused by simple errors where the 9084 is not appropriately set for the type of signal being received by the card.
Note: The error indications shown below are typical for the corresponding error con- ditions listed. Other error indications not specified here may also be displayed on DashBoard™ and/or the 9084 card edge status indicators.
Note: Where errors are displayed on both the 9084 card and network remote con- trols, the respective indicators and displays are individually described in this section.
Table
| Symptom | Error/Condition | Corrective Action |
|
|
|
|
• | DashBoard™ shows Video | No video input present | Make certain intended video source is |
| yellow icon and Input Invalid |
| connected to appropriate 9084 card video input. |
| message in 9084 Card Info |
| Make certain BNC cable connections between |
| pane. |
| frame Rear I/O Module for the card and signal |
|
|
| source are OK. |
• Card edge Input Format LEDs |
|
| |
| show continuous cycling. |
|
|
|
|
|
|
• | DashBoard™ shows Frame | Frame sync reference not | • If external frame sync reference is not |
| Sync red icon and Reference | properly selected or not being | intended to be used, make certain the |
| Invalid message in 9084 Card | received | Framesync Enable selection list is set to Off |
| Info pane. |
| or Input Video as desired. |
|
|
| • If external frame sync reference is intended to |
|
|
| be used, make certain selected external |
|
|
| frame sync reference is active on frame sync |
• Card edge red ERR indicator |
| 8310 frame bus. (External reference signals | |
| Reference 1 and Reference 2 are distributed | ||
| illuminated. |
| |
|
| to the 9084 and other cards via an 8310 | |
|
|
| |
|
|
| frame bus.) Refer to Framesync function |
|
|
| submenu tab on page |
|
|
| information. |
|
|
|
|
9084 PRODUCT MANUAL |