Indication | Description | Corrective actions |
|
|
|
OverHeat | Head overheat | Wait until the head temperature goes down. |
Cooling |
| When the temperature becomes low, the |
|
| remaining printing resumes. |
|
|
|
Stop | Stop key pressed | Enters a pause after displaying the stop by the |
|
| Stop key. |
|
| If the Pause key is pressed, the printing will |
|
| resume. |
|
| If the Stop key is pressed again, the stored |
|
| printing contents will be lost and "on line" will |
|
| turn on. |
|
|
|
Cancel | Stop command | Displays the stop by the stop command, |
| reception | discards the stored printing contents, and |
| (communication | enters a pause. |
| control) | If the Pause key is pressed, "on line" will turn |
|
| |
|
| on. |
|
|
|
HeadOpen | Mechanism head | Close the mechanism head. |
| open |
|
|
|
|
PaperEnd | Paper end (no paper | Install the paper. |
| left) |
|
|
|
|
PaperErr | Paper out (paper | Check the contents and clear with the Stop |
| position can't be | key. |
| detected) | Correct the faulty setting of the paper detection |
|
| |
|
| (paper gap, black line, continuous paper). |
|
| Correct the faulty parameter for paper (max. |
|
| length, continuous paper). |
|
| Adjust the sensor or change for the paper that |
|
| accepts the paper position detection. |
|
| Specify the length for detection miss checking |
|
| with the M command. |
|
| When the paper position can't be detected |
|
| during paper feeding by the specified length, it |
|
| is judged error. Generally specify the length |
|
| about three times the label length. |
|
| In case of the continuous paper, specify the |
|
| label length with the C c ommand. |
|
| Difference between the maximum and |
|
| minimum values of the sensor reading voltage |
|
| must be 0.8 V or more. |
|
| Sensor adjustments and paper characteristic |
|
| verification (voltage verification) can be |
|
| performed with the Maintenance mode. |
|
|
|