The relationship between the offset adjustment screw and the print head heating element is shown below:
a) Print head position for label
Offset adjustment screw
Offset verification window
a
Heating element
b) Print head position for tag
| Offset adjustment | Offset verification window |
| screw | |
|
| |
Heating element |
| b |
|
|
2When print darkness on the left and right sides of the label is not equal:
Adjustments may be needed if paper with different width is used. Print darkness is affected by the amount of pressure on the print head so it must be adjusted with the head pressure adjustment screw if necessary.
The pressure on the right side of the print head, viewed from the front panel, is adjusted by turning the head pressure adjustment screw.
Turning the screw clockwise decreases the pressure, and turning the screw counterclockwise increases the pressure.
The condition of the right side of the print head can be checked through the upper frame window, which is located at the front of the printer mechanism unit.