Citizen CMP-10 manual GS W n

GS W n

[Function]	Setting the print area width
[Code]	<1D>H<57>H<nL><nH>
[Range]	{0 =< nL =< FF(Hex)}
	{0 =< nH =< FF(Hex)}
[Outline]	Sets the print area width specified by nL and nH.

•The print area width will be [(nL + nH ⋅ 256) ⋅ 1/203] inches.

Printable Area

Left Margin Printable Area With

[Caution] • This command only works when it is entered at the beginning of a line.

•If the value entered with this command exceeds the printable area for one line, the entire area except the left margin is set as the print area width.

•For calculation of print area width, the basic pitch 1/203 inch for horizontal direction is used.

(1)The print area is extended toward the right to accommodate the first character, but not wider than the printable area.

Printable Area

A

Extended toward the right

Left Margin

Printable Area Width

(2)When sufficient area cannot be secured even by executing the processing (1), the print area is extended to the left (decreasing left margin).

Printable Area

A
Left Margin	(1) Extended
(2) xxxx	toward the right

Printable Area Width

— 48 —