Boca Research 2x2, Turbo1x1 manual Change displayed settings to standard addresses such as

Page 27

27

5.Select a device and press ENTER. Resources for the device are then displayed:

Address

IRQ

DMA

6. Change displayed settings to standard addresses such as:

Printer Ports:	378, 278
Com Ports:	3F8, 2F8, 3E8, 2E8
IO Adapter:	100, 110, 120, 130

You may select “Custom” to enter other valid settings.

7.If you choose an address currently in use, IOSETUP will tell you. Choose another valid setting.

8.You may press ESC to return to a previous menu. When done, select “Quit Program”. If any changes are made you will have to reboot your system.

Driver Installation

Image 27

Contents Adapter Page Before You Begin your Installation Damaged or Missing Items Contents Getting Started Turbo 1x1 1 SERIAL/1 Parallel Port Driver DisketteExpress Install SERIAL/2 Parallel Ports TurboSERIAL/1 Parallel Port Express Install Section One Introduction Introduction Series23456789012345 Select Section Two Physical InstallationIO Turbo Series Turbo 2x2 Suggested Configuration Turbo 1x1 Suggested Configuration Windows 98 Users Section Three Windows 98/95 ConfigurationWindows 95 Users Update Device Driver WizardNew Hardware Found Dialog Box Go to the Control Panel, System, Device Manager All Versions of WindowsDriver Installation IO Turbo Series DOS Section Four Windows 3.x/DOS ConfigurationIf a NON Plug and Play System is Detected Change displayed settings to standard addresses such as Symptom Possible Remedy Appendix a TroubleshootingTroubleshooting My system locks up Appendix B Windows NT Configuration Technical NotesWindows NT Notes Troubleshooting InstallingSerial Port a and B 9-pin Line Name Pin # Appendix C Pin AssignmentsParallel Port a and B 25-pin Line Name Pin # Appendix D Servicing Your Boca Product IO Turbo Series Servicing Your Boca Product FCC Compliance Limited Warranty