Boca Research 2x2, Turbo1x1 manual Section Four Windows 3.x/DOS Configuration, Dos

Page 25

25

Section Four: Windows 3.x/DOS

Configuration

1.Power up your system as you normally would. If your system boots into Windows, exit to DOS.

2.Insert the driver diskette. Go to the A:\ prompt, type INSTALL and press ENTER.

IF A PLUG AND PLAY SYSTEM IS DETECTED, continue below (for non Plug and play, continue with page 26).

1.A screen is displayed informing you that your Plug and Play system has detected the new I/O Turbo Series board.

2.You may use your own Plug and Play configuration utility, or select “Install the Locate Utility” to determine how your system configured the I/O Turbo Series board.

3.You will be asked to indicate which operating system you have:

•Windows 3.1, 3.11, Windows for Workgroups 3.11

•DOS

Follow all on-screen directions. Files are then copied to your hard drive. If you are running Windows, you are asked if you want to update your WIN.INI file. Select Yes.

You have the option of re-installing and selecting IOSETUP to change settings which were assigned to the new device. This will require a working knowledge of COM/LPT port and IRQ settings and how these resources are assigned in your system.

Driver Installation

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Adapter Page Before You Begin your Installation Damaged or Missing Items Contents Getting Started Turbo 1x1 1 SERIAL/1 Parallel Port Driver DisketteExpress Install SERIAL/2 Parallel Ports TurboSERIAL/1 Parallel Port Express Install Section One Introduction Introduction Series23456789012345 Select Section Two Physical InstallationIO Turbo Series Turbo 2x2 Suggested Configuration Turbo 1x1 Suggested Configuration Windows 98 Users Section Three Windows 98/95 ConfigurationWindows 95 Users Update Device Driver WizardNew Hardware Found Dialog Box Go to the Control Panel, System, Device Manager All Versions of WindowsDriver Installation IO Turbo Series DOS Section Four Windows 3.x/DOS ConfigurationIf a NON Plug and Play System is Detected Change displayed settings to standard addresses such as Symptom Possible Remedy Appendix a TroubleshootingTroubleshooting My system locks up Technical Notes Appendix B Windows NT ConfigurationWindows NT Notes Troubleshooting InstallingSerial Port a and B 9-pin Line Name Pin # Appendix C Pin AssignmentsParallel Port a and B 25-pin Line Name Pin # Appendix D Servicing Your Boca Product IO Turbo Series Servicing Your Boca Product FCC Compliance Limited Warranty
Top Page Image Contents