Figure 3-1 Single Expansion Board Installation
Expansion Board
Remove screw (Labeled MH1 in Main PCB Screen). Install Male/Female
Standoff.
Main Control
Board
Install Female/Female
Aluminum Standoff.
Install Female/Female
Nylon Standoff.
Terminal tightening torque is 7 lb-in (0.8 Nm) maximum.
Figure 3-2 Single Expansion Board Installation
#6 Screw |
|
| Group 1 or 2 Expansion Board |
Long Aluminum or | Female/Female shown. Use Male/Female |
Nylon Standoff | in place of (MH1) screw Figure |
| Main Circuit Board |
Installation