15HP Size C and Larger AC Controls
(For all 15H Inverter, 21H Line Regen Inverter, 18H Vector, 22H Line Regen Vector and 23H Servo).
Single Expansion Board Installation
Procedure:
1.Be sure drive operation is terminated and secured.
2.Remove all power sources from the control.
3.Wait at least 5 minutes for internal capacitors to discharge.
4.Remove the four (4) Phillips head screws (1/4 turn) that secure the control cover. (On floor mounted G size enclosures, open the enclosure door).
5.Remove the control cover.
6.Slide the expansion board male connector into the female connector of the control board. See Figure
7.Securely mount the expansion board to the sheet metal mounting plate using the #6 screws provided in the installation hardware. See Figure
8.The mechanical installation of the expansion board is now complete. Refer to Section 4 of this manual and configure the jumpers as desired. Also complete the wiring before you proceed to step 9.
9.When complete, install the control cover using the four (4) Phillips head screws (1/4 turn). (On floor mounted G size enclosures, close the enclosure door).
10.Restore all power sources to the control.
11.Restore drive operation.