1-15HP Size A and B Controls
Dual Expansion Board Installation (Continued)
13.The mechanical installation of the first expansion board is now complete. Refer to the manual for the Group 2 board and configure any jumpers and switches as desired. Also complete the wiring for this board before you install the cover.
14.When complete, install the control cover using the four (4) Phillips head screws.
15.Restore all power sources to the control.
16.Restore drive operation.
Figure 3-3 Dual Expansion Board Installation
#6 Screw |
| |
| Group 2 Expansion Board | |
Short | Female Connector | |
| ||
Aluminum |
| |
Standoff | Male Connector | |
| ||
| Group 1 Expansion Board | |
Long | Female/Female shown. Use Male/Female | |
Aluminum or | ||
in place of (MH1) screw (Figure | ||
Nylon Standoff | ||
| ||
| Main Circuit Board |
Installation