Minolta PCL6 user manual Functions of the Detail Of Output Setting dialog box

Properties Settings Chapter 3

3-12

4. Setup tab

Functions of the Detail Of Output Setting dialog box

Allows you to make settings for the finishing functions, including stapling and folding.

(3)

(1)

(4)

(2)

(5)

C4027P211CA

(1)Staple (when the Finisher or Booklet Finisher is installed) Allows you to staple one set of printed documents at a time.

• Right Corner	Printed documents are stapled in the upper right
	corner.
• Upper 2-point	Printed documents are stapled at two points along the
	top edge.
• Left Corner	Printed documents are stapled in the upper left corner.
• Left 2-point	Printed documents are stapled at two points along the
	left edge.
• Right 2-point	Printed documents are stapled at two points along the
	right edge.

☞See p. 1-4 for an illustration.

NOTES

•If a Staple setting has been made, printed pages are fed out into the Primary Tray.

•If the capacity of the Finisher or Booklet Finisher is exceeded, the stapling operation may be canceled. Refer to the User Manual of the machine.

•If the original document for a print job consists of pages of different sizes, stapling may be canceled.

•Take care when printing a document consisting of pages facing different directions, since the stapling position will be determined by the direction of the first page.

•Certain sizes or kinds of paper cannot be selected. For details, refer to the User Manual of the machine.