Olivetti P20W, P26W manual Click the Start button and select Control Panel

1.Ensure that the TCP/IP protocol has been installed in Windows. This can be confirmed by checking the network settings from within the Control Panel. If TCP/IP has not been installed refer to the section below Installation of TCP/IP protocol.

2.If not already configured, a suitable IP address, Subnet Mask and Gateway address should be configured. Please refer to the on-line help if necessary. It is vital that the IP address entered is unique and valid. Entering an incorrect IP address may cause severe network problems. Please check the address with the network administrator.

3.If your network environment uses domain names, DNS should be enabled and configured on your system. However, this step is not essential to enable network printing.

4.Restart the operating system.

WINDOWS 2000

1.Click the [Start] button, select [Settings] and then click on [Network and Dial-up Connections].

2.Double-click the [Local Area Connection] icon. In the [Local Area Connection Status] dialogue box, click the [Properties] button.

3.If the TCP/IP protocol is not listed, in the [Local Area Connection Properties] dialogue box, click the [Install] button.

4.In the [Select Network Component Type] dialogue box, select [Protocol] and click the [Add] button.

5.In the [Select Network Protocol] dialogue box, select [TCP/IP Protocol] and click the [OK] button.

6.Click the [Close] button in the [Local Area Connection Properties] dialogue box.

7.Click the [Close] button in the [Local Area Connection Status] dialogue box.

WINDOWS XP

1.Click the [Start] button and select [Control Panel].

Microsoft Windows> 53