![](/images/new-backgrounds/1119103/11910329x1.webp)
Prepare The Printer
Installation and Removal
This section describes how to install the validator. To remove the validator, reverse the steps of this procedure.
Prepare The Printer
1. Set the printer power switch to O (Off).
WARNING Always unplug the printer power cord from the printer or power outlet before doing any installation procedure. Failure to remove power could result in injury to you and damage the equipment. You will be instructed when to apply power.
2.Unplug the printer power cord from the printer or the AC power source.
Factory Installation
If your printer has a factory installed validator, the ferrite, cable, wire saddle, and grommet have already been installed. Go to “Install The Brackets” on page 22.
Field Installation
If you are doing a field installation, you must install the ferrite, cable, wire saddle, and grommet. Go to “Install The Ferrite” on page 16.
15