Printronix PSA3 manual Advance Print Position Vertically, Align Sbcs Character with Dbcs Character

Chapter 3 Configuring The KSSM Emulation With Control Codes

FUNCTION	ASCII CODE	PAGE
Hangul Extension Commands (continued)
Turn Extending Table Character
On/Off	FS v n	78
Turn Underline On/Off	FS - n	80
Superset Command
Barcode Printing	SSCC c t	36
Graphics Printing: Select Bit Image	SSCC * m nL nH d1…dk	45
Turn On/Off OCRB Printing	ASSC 0 z n	78
Define User Defined Character	ASSC 0 2	40
Font Expansion	ASSC 0 e	43
Graphic Printing	ASSC 0 *	44
Master Select One-Line Attribute	ASSC 0 !	49

Advance Print Position Vertically

ASCII Code	ESC J n
Hex Code	1B 4A n
Dec Code	27 74 n
Purpose	Advances the vertical print position n/180 inch.
	Where:
	0 <= n <= 255
Comment	This command does not affect the horizontal print position.
	Advances paper to the top-of-form position on the next page if
	the ESC J command moves the print position below the
	bottom-margin position setting.

Align SBCS Character with DBCS Character

ASCII Code	FS U
Hex Code	28 85
Dec Code	1C 55
Purpose	Aligns two SBCS characters to fit the space normally occupied
	by a full-width DBCS character that does not have a half-width,
	subscript, or superscript feature.
Comment	A DBCS character with half-width, subscript, or superscript
	feature is treated as an SBCS character.
	The intercharacter space of the next character is set by the FS
	S command.
	In the default mode, the SBCS character aligns with the DBCS
	character.

34