Printronix P7000 H-Series, PSA3 manual Select Character Table, Select Condensed Printing

Select Character Table

Select Character Table

ASCII Code ESC t n

Hex Code	1B 74 n
Dec Code	27 116 n
Purpose	Selects the character table to be used for printing among the
	two character tables described below:
n = 0 or 48		Character table 0	0x80-0x9f Control code, 0xa0-0xff Italic
n = 1 or 49		Character table 1	0x80-0xff Printable code, IBM PC437
	Where:
	0 <= n <= 1, 48 <= n <= 49
	Currently, the setting on the front panel of “Alt. Set 80-9F”
	determines whether n = 0 would be treated as Control Code or
	Printable Code. Thus, this determines the setting n = 1.
Comment	This command affects the front panel setting of “Character Set.”
Select Condensed Printing
ASCII Code	SI
Hex Code	0F
Dec Code	15
Purpose	Enters condensed mode, in which character width is reduced
	as follows:
		Selected pitch		Condensed pitch
		10 cpi		17.14 cpi
		12 cpi		20 cpi
		Proportional		½ width
Comment
	This command is ignored under the following two conditions:
	15-cpi printing has been selected with the ESC g command.

This command reduces character width by about 50% when proportional spacing is selected with the ESC p command.

Cancel condensed printing with the DC2 command.

This command only takes effect in SBCS mode.

The default is Non-condensed printing.

57