Printronix SL5000r manual Hor Image Shift, Orientation

Page 43

QUICK SETUP Menu Items

the image is not affected by this parameter. The allowable range is –1.00 inches to the current Label Length value setting, up to a maximum of 12.80 inches, in 0.01 inch increments.

The default value is 0.00 inches.

Hor Image Shift

This menu item specifies the amount to shift an image left (–) or right (+) for precise positioning on the label. The actual width of the image is not affected by this parameter. The allowable range is –1.00 to +1.00 inches in 0.01 inch increments.

The default value is 0.00 inches.

Orientation

Specifies the image orientation to be used when printing the label.

•Portrait. The default. Portrait refers to vertical page orientation, where the height of a page is greater than its width. The top edge of the image is parallel to the leading edge of the media. The following example is viewed from the front of the printer.

NOTE: Portrait orientation applies to PGL® and VGL emulations. This is regarded as Inverse Portrait using PPI/ZGL.

4 inches

FEED

.media the of edge leading the to parallel is image the of edge top The

6 inches

Leading Edge

43

Image 43

Contents Quick Setup Guide Page Page Definitions Software License AgreementTermination of License Agreement Canada Communication NoticesDeclaration Of Conformity CE Notice European UnionTrademark Acknowledgements Taiwan Lithium Battery WarningTable of Contents Table of Contents Unpacking The Printer Unpacking And Installing The PrinterRemoving The Internal Packing Material Unpacking And Installing The PrinterInstallation InstallationControl Panel Controls And IndicatorsPower Switch Controls And IndicatorsLiquid Crystal JOB Select Key Control Panel KeysControl Panel Down Key in Menu mode Menu KeyLoading Media And Ribbon Loading Media And RibbonLoading Roll Media Loading Roll MediaMedia Roll Media Hanger Guide Media Width Media Damper Loading Roll Media Lower Media Sensor Fixed Guide Media Width Notch Loading Ribbon Loading Ribbon Loading Media And Ribbon Left Pressure Block Printing AdjustmentsPrinthead Pressure Adjustment Printhead Pressure Block AdjustmentsPositioning The Media Sensors Printing AdjustmentsFeed Positioning The Media SensorsRunning Auto Calibrate Calibrating The PrinterCalibrating The Printer Running Auto Calibrate Making a Media Profile Printout Making a Media Profile Printout Gap Sensing255 191 127 Advanced Gap Sensing Paper Out075 Changing The Active IGP Emulation Configuring The PrinterQuick Setup Menu Quick Setup MenuCont. from previous Print Speed Quick Setup Menu ItemsPrint Mode Print IntensityMedia Handling Quick Setup Menu ItemsVer Image Shift Paper Feed ShiftLabel Length Label WidthOrientation Hor Image ShiftEdgetopTheof isimagethe thetoparallelleft theofedgemedia Quick Setup Menu Items Gap Sensing for Smart Labels Gap/Mark SensorAuto Calibrate Validator Funct Save ConfigActive IGP Emul SMT Select Tool Power-Up ConfigSMT Status SMT Sel ToolsetAuto Save Configuration Saving The ConfigurationSaving The Configuration Loading a Saved Configuration Selecting The Power-Up ConfigurationPrinting a Configuration Printing a ConfigurationRun a Barcode Demo Test Exterior CleaningGeneral Cleaning Cleaning The Printhead, Platen Roller, Media SensorsCleaning The Printhead, Platen Roller, And Media Sensors Platen Roller CleaningMedia Sensor Cleaning Media Damper CleaningCleaning Upper Media Sensor From Printhead Heating Elements Repacking The Printer Repacking The PrinterMedia Cover window side Straps not supplied Contact Information Contact InformationPrintronix Customer Support Center Printronix Supplies DepartmentCorporate Offices For More InformationCorporate Offices Page Page 178423-001