Printronix SL5000r manual Taiwan Lithium Battery Warning, Trademark Acknowledgements

Page 8

Taiwan

Lithium Battery Warning

The controller board contains a lithium battery sealed inside the real-time clock chip. Do not disassemble the chip to replace the battery. Do not dispose of the chip by incineration. Failure to comply may cause the battery to explode. Contact your local waste agency for the correct disposal procedure.

Printronix makes no representations or warranties of any kind regarding this material, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. Printronix shall not be held responsible for errors contained herein or any omissions from this material or for any damages, whether direct, indirect, incidental or consequential, in connection with the furnishing, distribution, performance or use of this material. The information in this manual is subject to change without notice.

This document contains proprietary information protected by copyright. No part of this document may be reproduced, copied, translated or incorporated in any other material in any form or by any means, whether manual, graphic, electronic, mechanical or otherwise, without the prior written consent of Printronix.

COPYRIGHT © 2005 PRINTRONIX, INC. All rights reserved.

Trademark Acknowledgements

Printronix and PGL are registered trademarks of Printronix, Inc.

SL5000r and T5000r are trademarks of Printronix, Inc.

Image 8

Contents Quick Setup Guide Page Page Software License Agreement DefinitionsTermination of License Agreement Communication Notices CanadaCE Notice European Union Declaration Of ConformityTaiwan Lithium Battery Warning Trademark AcknowledgementsTable of Contents Table of Contents Unpacking And Installing The Printer Unpacking The PrinterUnpacking And Installing The Printer Removing The Internal Packing MaterialInstallation InstallationControls And Indicators Power SwitchControls And Indicators Control PanelLiquid Crystal Control Panel Keys JOB Select KeyDown Key in Menu mode Menu Key Control PanelLoading Media And Ribbon Loading Media And RibbonLoading Roll Media Loading Roll MediaMedia Roll Media Hanger Guide Media Width Media Damper Loading Roll Media Lower Media Sensor Fixed Guide Media Width Notch Loading Ribbon Loading Ribbon Loading Media And Ribbon Printing Adjustments Printhead Pressure AdjustmentPrinthead Pressure Block Adjustments Left Pressure BlockPrinting Adjustments Positioning The Media SensorsPositioning The Media Sensors FeedCalibrating The Printer Calibrating The PrinterRunning Auto Calibrate Running Auto Calibrate Making a Media Profile Printout Gap Sensing Making a Media Profile Printout255 191 127 Advanced Gap Sensing Paper Out075 Configuring The Printer Changing The Active IGP EmulationQuick Setup Menu Quick Setup MenuCont. from previous Quick Setup Menu Items Print ModePrint Intensity Print SpeedQuick Setup Menu Items Media HandlingPaper Feed Shift Label LengthLabel Width Ver Image ShiftHor Image Shift OrientationEdgetopTheof isimagethe thetoparallelleft theofedgemedia Quick Setup Menu Items Gap/Mark Sensor Gap Sensing for Smart LabelsAuto Calibrate Active IGP Emul Save ConfigValidator Funct Power-Up Config SMT StatusSMT Sel Toolset SMT Select ToolSaving The Configuration Saving The ConfigurationAuto Save Configuration Selecting The Power-Up Configuration Loading a Saved ConfigurationPrinting a Configuration Printing a ConfigurationRun a Barcode Demo Test Cleaning General CleaningCleaning The Printhead, Platen Roller, Media Sensors ExteriorPlaten Roller Cleaning Media Sensor CleaningMedia Damper Cleaning Cleaning The Printhead, Platen Roller, And Media SensorsCleaning Upper Media Sensor From Printhead Heating Elements Repacking The Printer Repacking The PrinterMedia Cover window side Straps not supplied Contact Information Printronix Customer Support CenterPrintronix Supplies Department Contact InformationCorporate Offices For More InformationCorporate Offices Page Page 178423-001